STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY(for Sedan) INSPECTION

PROCEDURE


  1. INSPECT ECO RUN CANCEL SWITCH ASSEMBLY


    1. A00Y8LDC07
      *a

      Component without harness connected

      (Eco Run Cancel Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      8 (ECU) - 5 (E) Pushed Below 1 Ω
      Not pushed 10 kΩ or higher

      If the result is not as specified, replace the eco run cancel switch assembly.

    2. A00Y8LDC05
      *a

      Component without harness connected

      (Eco Run Cancel Switch Assembly)

      Apply battery voltage between the terminals of the switch, and check the illumination condition of the eco run cancel switch assembly.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 7 (ILL+)

      Battery negative (-) → 6 (ILL-)

      		 Illuminates

      If the result is not as specified, replace the eco run cancel switch assembly.