CRUISE CONTROL SYSTEM(except 1ND-TV, 8NR-FTS) Cruise Main Indicator Light Circuit

DESCRIPTION

• The ECM turns on the cruise control indicator by sending indicator output demand signals to the combination meter assembly using CAN communication.

• The cruise control indicator illuminates in green when the cruise control system has been turned on using the ON-OFF switch. If a malfunction is detected, the cruise control indicator changes to amber (w/ multi-information display (segment LCD type)), or the cruise control indicator goes out and a warning message is displayed (w/ multi-information display (dot LCD type)).

• The cruise control indicator circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

PROCEDURE

1. PERFORM ACTIVE TEST USING GTS

   
   

   1. Connect the GTS to the DLC3.

   2. Turn the ignition switch to ON.

   3. Turn the GTS on.

   4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

   5. Check the cruise control indicator by performing the Active Test.

      
      Body Electrical > Combination Meter > Active Test

      Tester Display	Measurement Item	Control Range	Diagnostic Note
      Indicat. Lamp Cruise	Cruise control indicator (illuminated in green)	ON / OFF	-
      Cruise Indicator	Cruise control indicator (illuminated in amber)	ON / OFF	w/ Multi-information Display (Segment LCD Type)

      
      Body Electrical > Combination Meter > Active Test

      Tester Display
      Indicat. Lamp Cruise

      
      Body Electrical > Combination Meter > Active Test

      Tester Display
      Cruise Indicator

      OK
      The cruise control indicator goes on or off.

      Result
      Proceed to OK NG

   
   

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

   NG

   REPLACE COMBINATION METER ASSEMBLY for Hatchback, Wagon: Click here REPLACE COMBINATION METER ASSEMBLY for Sedan: Click here