GLOW PLUG ON-VEHICLE INSPECTION

PROCEDURE


  1. DISCONNECT ENGINE WIRE

    Click here

  2. INSPECT GLOW PLUG ASSEMBLY


    1. Disconnect the 4 glow plug assembly connectors.

    2. A01LVV8

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      Glow plug assembly terminal - Glow plug assembly body 20°C (68°F) 0.1 to 0.9 Ω

      If the result is not as specified, replace the glow plug assembly.

      Note


      • Be careful not to damage the glow plug assembly as this may cause an open circuit or shorten the life of the glow plug assemblies.

      • Clean any oil on the terminal and Bakelite washer with a dry cloth.

    3. Connect the 4 glow plug assembly connectors.

  3. CONNECT ENGINE WIRE

    Click here