IGNITION SWITCH INSPECTION

PROCEDURE


  1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY


    1. A00Y7MXC01
      *a

      Component without harness connected

      (Ignition or Starter Switch Assembly)
      *b LOCK
      *c ACC
      *d ON
      *e START

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        Between all terminals LOCK 10 kΩ or higher
        2(ACC) - 4(AM1) ACC Below 1 Ω
        1(IG1) - 2(ACC) - 4(AM1) ON Below 1 Ω
        5(AM2) - 6(IG2)
        1(IG1) - 3(ST1) - 4(AM1) START Below 1 Ω
        5(AM2) - 6(IG2) - 7(ST2)

        If the result is not as specified, replace the ignition or starter switch assembly.