ENGINE SWITCH REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 1 METER HOOD CLUSTER (for LHD)

    Click here

  4. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (for LHD)

    Click here

  5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for LHD)

    Click here

  6. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for LHD)

    Click here

  7. REMOVE NO. 1 SWITCH HOLE BASE (for LHD)

    Click here

  8. REMOVE ENGINE SWITCH (for LHD)


    1. B004539

      Disengage the 2 claws and remove the engine switch.

  9. REMOVE NO. 1 METER HOOD CLUSTER (for RHD)

    Click here

  10. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for RHD)

    Click here

  11. REMOVE INSTRUMENT SIDE PANEL RH (for RHD)

    Click here

  12. REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for RHD)

    Click here

  13. REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for RHD)

    Click here

  14. REMOVE NO. 2 SWITCH HOLE BASE (for RHD)

    Click here

  15. REMOVE ENGINE SWITCH (for RHD)


    1. B0041W7

      Disengage the 2 claws and remove the engine switch.