STARTER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

      Click here

    • When the starter assembly is replaced, "ST NO. 1 relay" must be also replaced.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 1 ENGINE COVER

    Click here

  4. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  5. REMOVE BATTERY

    Click here

  6. REMOVE BATTERY CARRIER

    Click here

  7. DISCONNECT NO. 1 VACUUM PIPE


    1. B00431T

      Using an E7 "TORX" socket wrench, remove the bolt and disconnect the No. 1 vacuum pipe from the cylinder block sub-assembly.

    2. Remove the O-ring from the No. 1 vacuum pipe.

  8. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE


    1. B00433F

      Disengage the 6 clamps and disconnect the No. 2 engine wire from the engine oil level dipstick guide.

    2. Remove the engine oil level dipstick.

    3. B0041LN

      Disengage the clamp and disconnect the fuel feed pipe sub-assembly from the engine oil level dipstick guide.

    4. Using a T25 "TORX" socket wrench, remove the bolt and engine oil level dipstick guide.

    5. Remove the O-ring from the engine oil level dipstick guide.

  9. REMOVE STARTER ASSEMBLY


    1. B00444K

      Open the terminal cap.

    2. Remove the nut and disconnect the No. 2 engine wire from the starter assembly.

    3. Remove the nut and disconnect the engine wire from the starter assembly.

    4. B0041V0

      Using an E14 "TORX" socket wrench, remove the 2 bolts and starter assembly.