ENGINE SWITCH(for Hatchback, Wagon) INSPECTION

PROCEDURE


  1. INSPECT ENGINE SWITCH


    1. Measure the resistance according to the value(s) in the table below.

      A00Y8LBC06
      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      5 (SS1) - 6 (AGND) Not pushed 10 kΩ or higher
      1 (SS2) - 6 (AGND)
      5 (SS1) - 6 (AGND) Pushed Below 1 Ω
      1 (SS2) - 6 (AGND)

      If the result is not as specified, replace the engine switch.

    2. Apply battery voltage between the terminals of the switch, and check the illumination condition of the engine switch.

      Note


      • If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.

      • If the voltage is too low, the indicator will not illuminate.

      Standard
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 9 (SWIL)

      Battery negative (-) → Terminal 6 (AGND)

      Illuminates
      A00Y8LBC07
      *a Indicator Light - -

      If the result is not as specified, replace the engine switch.