TRANSMITTER BATTERY(w/ Entry and Start System) REPLACEMENT

PROCEDURE


  1. REMOVE TRANSMITTER BATTERY

    Note

    Take extra care when handling these precision electronic components.


    1. A00YB2J

      Push the release hook knob and extract the mechanical key.

    2. A00Y6MYC08
      *a Protective Tape

      Insert a precision screwdriver into the gap, and turn the screwdriver to detach the transmitter housing cover.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A00Y5L7

      Disengage the 2 claws and remove the cover.

    4. A00Y8ZDC04
      *a Protective Tape

      Insert a precision screwdriver into the gap and gently remove the transmitter battery.

      Note


      • Do not push the terminals with your finger.

      • Do not forcibly pry up the transmitter battery. The terminals may be damaged.

      • Do not touch the transmitter battery with wet hands. Water may cause rust.

      • Do not touch or move any components inside the transmitter. It may interfere with proper operation.

      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.

      Tech Tips

      Tape the screwdriver tip before use.

  2. INSTALL TRANSMITTER BATTERY


    1. A00YB0F

      Install a new transmitter battery with the positive (+) side facing upward, as shown in the illustration.

      Note


      • Do not bend the transmitter battery electrode during insertion.

      • Keep the transmitter cover interior free of dust and oil.

      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.

    2. A00Y5W2

      Engage the 2 claws to install the cover.

    3. A00Y79S

      Install the transmitter housing cover by pressing down on it as shown in the illustration.

    4. A00YB22

      Insert the mechanical key into the transmitter.

    5. Press one of the transmitter switches and check that the LED illuminates.

      OK
      Transmitter LED illuminates when the switch is pressed.