WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Entry and Start System) DIAGNOSIS SYSTEM


  1. DESCRIPTION

    The ECU stores trouble codes when malfunctions occur.

    The diagnostic system allows for reading of the trouble codes from the DLC3.

    Use the GTS to help diagnose and repair the problem.

  2. CHECK DLC3


    1. Check the DLC3.

      Click here

  3. INSPECT BATTERY VOLTAGE


    1. Measure the vehicle battery voltage.

      If the voltage is below 11 V, recharge or replace the battery.

    2. SELF-DIAGNOSTIC MODE (USING GTS)


      1. Connect the GTS to the DLC3.

      2. Turn the engine switch on (IG).

      3. Turn the GTS on.

      4. Enter the following menus: Body Electrical / Entry&Start / Utility / Wireless Door Lock Diagnosis Mode.


        Body Electrical > Entry&Start > Utility
      3. Tester Display
      Wireless Door Lock Diagnosis Mode

  • Proceed to the next step in accordance with the prompts on the GTS screen.

  • A012N9VE27
    Wireless Door Lock Buzzer Output
    *1 ON
    *2 OFF
    *3 T1: 0.125 seconds
    *4 T2: 0.5 seconds

    Check that the system has switched to self-diagnostic mode by checking the wireless door lock buzzer output pattern.

  • Check the diagnostic outputs when an electrical key transmitter sub-assembly switch is pressed. The diagnostic outputs can be checked by the interior light and wireless door lock buzzer patterns.

    A012KZ4E92
    Result
    Wireless Door Lock Buzzer Output Suspected Area
    A Normal (No malfunction)
    B Register wireless code
    C Wave interference or malfunction of a related component