REAR DOOR LOCK(for Sedan) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. PRECAUTION (w/ Power Window)

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR ARMREST ASSEMBLY

    Click here

  4. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

  5. REMOVE REAR DOOR ARMREST UPPER BASE PANEL (w/o Power Window)

    Click here

  6. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

    Click here

  7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  8. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

  9. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  10. DISCONNECT REAR DOOR WEATHERSTRIP

    Click here

  11. REMOVE REAR DOOR GLASS RUN

    Click here

  12. REMOVE NO. 1 REAR DOOR VENT SEAL

    Click here

  13. REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

  14. REMOVE REAR DOOR QUARTER WINDOW GLASS

    Click here

  15. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  16. REMOVE REAR DOOR LOCK WITH MOTOR ASSEMBLY


    1. B0042LDC01
      *a Release Plate

      Disconnect the connector.

    2. Using a T30 "TORX" socket wrench, remove the 3 screws.

    3. Move the rear door lock with motor assembly downward, disconnect it from the release plate of the rear door outside handle frame and remove the rear door lock with motor assembly.

    4. When reusing the rear door lock with motor assembly:


      1. B00448V

        Remove the door lock wiring harness seal from the rear door lock with motor assembly.

  17. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

    Click here

  18. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

    Click here