EXHAUST GAS TEMPERATURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL NO. 2 EXHAUST GAS TEMPERATURE SENSOR

    Note

    If the No. 2 exhaust gas temperature sensor is dropped, replace it with a new one.


    1. Using a 14 mm union nut wrench, install the No. 2 exhaust gas temperature sensor to the exhaust manifold converter sub-assembly.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.

      Click here

    2. Engage the No. 2 exhaust gas temperature sensor connector clamp.

  2. INSTALL NO. 3 EXHAUST GAS TEMPERATURE SENSOR

    Note

    If the No. 3 exhaust gas temperature sensor is dropped, replace it with a new one.


    1. A012K8ZC01
      *1 White Tube
      *2 Protective Tube

      Temporarily install the No. 3 exhaust gas temperature sensor.

    2. Engage the No. 3 exhaust gas temperature sensor connector clamp.

    3. Temporarily install the No. 3 exhaust gas temperature sensor connector clamp with the nut.

      Note

      Make sure the clamp is aligned with the white tube of the wire harness as shown in the illustration.

    4. Tighten the nut.

      Torque:
      6.4 N*m  { 65 kgf*cm, 57 in.*lbf }

    5. Using a 14 mm union nut wrench, install the No. 3 exhaust gas temperature sensor.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note


      • When tightening the union nut, make sure that the protective tube of the No. 3 exhaust gas temperature sensor is within the area shown in the illustration.

      • Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.

        Click here

  3. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

    Click here

  4. INSTALL NO. 4 MANIFOLD CONVERTER INSULATOR

    Click here

  5. INSTALL ENGINE ASSEMBLY

    Click here

  6. INSTALL EXHAUST GAS TEMPERATURE SENSOR

    Note

    If the exhaust gas temperature sensor is dropped, replace it with a new one.


    1. Using a 14 mm union nut wrench, install the exhaust gas temperature sensor.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench.

      Click here

    2. Engage the exhaust gas temperature sensor connector clamp.

  7. INSTALL NO. 1 ENGINE COVER

    Click here