FUEL SENDER GAUGE ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT FUEL SENDER GAUGE ASSEMBLY


    1. Check that the float moves smoothly between F and E.

    2. A01M2N3C01
      *a

      Component without harness connected

      (Fuel Sender Gauge Assembly)

      Type A:


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Float Level Specified Condition
        1 - 2 F 12.0 to 18.0 Ω
        Between F and E 12.0 to 415.0 Ω (Gradually changes)
        E 405.0 to 415.0 Ω

        If the result is not as specified, replace the fuel sender gauge assembly.

    3. A01M308C01
      *a

      Component without harness connected

      (Fuel Sender Gauge Assembly)

      Type B:


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Float Level Specified Condition
        1 - 2 F 13.5 to 16.5 Ω
        Between F and E 13.5 to 414.5 Ω (Gradually changes)
        E 405.5 to 414.5 Ω

        If the result is not as specified, replace the fuel sender gauge assembly.