FUEL SENDER GAUGE ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT FUEL SENDER GAUGE ASSEMBLY


    1. Check that the float moves smoothly between F and E.

    2. A00Y6IQC03
      *a

      Component without wire harness connected

      (Fuel Sender Gauge Assembly)

      Check the fuel sender gauge assembly resistance.


      1. Measure the resistance between terminals 1 and 2 of the connector according to the value(s) in the table below.

        Standard Resistance
        Float Level Resistance (Ω)
        F 12.0 to 18.0
        Between E and F 12.0 to 415.0 (Gradually changes)
        E 405.0 to 415.0

        If the result is not as specified, replace the fuel sender gauge assembly.