CYLINDER HEAD GASKET REMOVAL

PROCEDURE

1. REMOVE CHAIN SUB-ASSEMBLY

   Click here

2. REMOVE CAMSHAFT BEARING CAP

   Click here

3. REMOVE CAMSHAFT

   
   

   1. 

      Remove the camshaft.

4. REMOVE NO. 2 CAMSHAFT

   
   

   1. 

      Remove the No. 2 camshaft.

5. REMOVE NO. 1 CAMSHAFT BEARING

   Click here

6. REMOVE NO. 2 CAMSHAFT BEARING

   Click here

7. REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY

   Click here

8. REMOVE VALVE LASH ADJUSTER ASSEMBLY

   Click here

9. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY

   Click here

10. REMOVE CYLINDER HEAD SUB-ASSEMBLY

    
    

    1. 

       Using a 10 mm bi-hexagon wrench, uniformly loosen and remove the 10 cylinder head set bolts and 10 plate washers in several steps and in the order shown in the illustration.

       Note

       
       

       • Removing the cylinder head set bolts in the wrong order may cause warpage or cracking of the cylinder head sub-assembly.

       • Do not drop the plate washers into the cylinder head sub-assembly.

    2. Using a screwdriver with its tip wrapped with protective tape, pry between the cylinder head sub-assembly and cylinder block sub-assembly, and remove the cylinder head sub-assembly.

       Note

       Be careful not to damage the contact surfaces of the cylinder head sub-assembly and cylinder block sub-assembly.

11. REMOVE CYLINDER HEAD GASKET

    
    

    1. 

       Remove the cylinder head gasket.

12. INSPECT NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY

    Click here

13. INSPECT VALVE LASH ADJUSTER ASSEMBLY

    Click here

14. INSPECT CYLINDER HEAD SET BOLT

    Click here