FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING CHAIN COVER OIL SEAL


    1. Apply MP grease to the lip of a new timing chain cover oil seal.

      Note

      Keep the lip free from foreign matter.

    2. A01T9O7N07

      Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the front timing chain cover sub-assembly retainer edge.

      SST
      09223-22010

      Note


      • Wipe off excess grease from the crankshaft.

      • Do not tap the timing chain cover oil seal at an angle.

      Tech Tips

      Timing chain cover oil seal tap in depth: - 1.0 to 1.0 mm (-0.0397 to 0.0397 in.)

  2. INSTALL CRANKSHAFT PULLEY


    1. Align the pulley set key with the key groove of the crankshaft pulley.

    2. A01TCKBC02
      *a Turn
      *b Hold

      Using SST, hold the crankshaft pulley in place and tighten the pulley bolt.

      for 86 mm (3.39 in.) Bolt Pitch Type:

      SST
      09213-58014   ( 91551-80840 )
      09330-00021

      for 64 mm (2.52 in.) Bolt Pitch Type:

      SST
      09213-54015
      Torque:
      190 N*m  { 1937 kgf*cm, 140 ft.*lbf }

      Tech Tips

      For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

  3. INSTALL V-RIBBED BELT

    Click here

  4. ADJUST V-RIBBED BELT

    Click here

  5. INSPECT V-RIBBED BELT

    Click here

  6. INSPECT FOR ENGINE OIL LEAK

  7. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  8. INSTALL REAR ENGINE UNDER COVER RH

    Click here

  9. INSTALL NO. 1 ENGINE UNDER COVER (for Full Cover Type)

    Click here

  10. INSTALL NO. 1 ENGINE UNDER COVER (for Half Cover Type)

    Click here

  11. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }