CYLINDER HEAD GASKET REMOVAL

CAUTION / NOTICE / HINT

Note


  • The camshaft housing sub-assembly is replaced with an assembled unit that includes the camshaft housing sub-assembly, camshafts, camshaft bearing caps, valve rocker shaft and valve rocker arm lost motion damper sub-assembly. If disassembled, replace the camshaft housing sub-assembly.

  • The camshafts cannot be replaced by themselves.

    A01T9CHC04
    *1 Continuously Variable Valve Lift Controller Assembly *2 Camshaft Housing Sub-assembly
    *3 Set of parts that are replaced together - -

PROCEDURE


  1. REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY

    Click here

  2. REMOVE FUEL TUBE SUB-ASSEMBLY

    Click here

  3. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

    Click here

  4. REMOVE NO. 1 DELIVERY PIPE SPACER

    Click here

  5. REMOVE FUEL INJECTOR ASSEMBLY

    Click here

  6. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

    Click here

  7. REMOVE MANIFOLD STAY

    Click here

  8. REMOVE EXHAUST MANIFOLD

    Click here

  9. REMOVE NO. 1 WATER BY-PASS PIPE

    Click here

  10. REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY

    Click here

  11. REMOVE VALVE LASH ADJUSTER ASSEMBLY

    Click here

  12. REMOVE VALVE STEM CAP

    Click here

  13. REMOVE CYLINDER HEAD SUB-ASSEMBLY


    1. A01TCP1N16

      Using a 10 mm bi-hexagon wrench, uniformly loosen and remove the 10 cylinder head bolts and 10 plate washers in several steps in the sequence shown in the illustration.

      Note


      • Removing the cylinder head set bolts in the wrong order may cause warpage or cracking of the cylinder head sub-assembly.

      • Do not drop the plate washers into the cylinder head sub-assembly.

    2. Using a screwdriver remove the cylinder head sub-assembly by prying between the cylinder head sub-assembly and cylinder block sub-assembly, and remove the cylinder head sub-assembly.

      Tech Tips

      Tape the screwdriver tip before use.

      Note

      Be careful not to damage the contact surfaces of the cylinder head sub-assembly and cylinder block sub-assembly.

  14. REMOVE CYLINDER HEAD GASKET


    1. A01TCZF

      Remove the cylinder head gasket.