FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING CHAIN COVER OIL SEAL


    1. Apply MP grease to the lip of a new timing chain cover oil seal.

      Note

      Keep the lip free from foreign matter.

    2. A0030W8C02
      *a Tap in depth

      Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover assembly edge.

      SST
      09223-22010

      Note


      • Keep the lip free from foreign matter.

      • Do not tap in the timing chain cover oil seal at an angle.

      Tech Tips

      Timing chain cover oil seal tap in depth: - 0.5 to 0.5 mm (- 0.0197 to 0.0197 in.)

  2. INSTALL CRANKSHAFT PULLEY


    1. A002ZO5C02
      *a Hold
      *b Turn

      Using SST, hold the crankshaft pulley in place and tighten the crankshaft pulley set bolt.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
      Torque:
      180 N*m  { 1835 kgf*cm, 133 ft.*lbf }

  3. INSTALL V-RIBBED BELT

    Click here

  4. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  5. INSPECT FOR ENGINE OIL LEAK

    Click here

  6. INSTALL REAR ENGINE UNDER COVER RH

    Click here

  7. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

  8. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }