FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING CHAIN COVER OIL SEAL


    1. Apply MP grease to the lip of a new timing chain cover oil seal.

      Note

      Keep the lip free of foreign matter.

    2. A01TC8DN05

      Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover sub-assembly.

      SST
      09223-22010

      Note


      • Do not tap in the timing chain cover oil seal at an angle.

      • Wipe off excess grease from the crankshaft.

      Tech Tips

      Timing chain cover oil seal tap in depth: -0.5 to 1.0 mm (-0.0197 to 0.0394 in.)

  2. INSTALL CRANKSHAFT PULLEY


    1. A01TC0DC01
      *a Hold
      A01TCE3 Turn

      Align the pulley set key with the key groove of the crankshaft pulley, then install the crankshaft pulley.

    2. Using SST, install the crankshaft pulley bolt.

      SST
      09960-10010   ( 09962-01000, 09963-01000 )
      Torque:
      128 N*m  { 1305 kgf*cm, 94 ft.*lbf }

  3. INSTALL V-RIBBED BELT

    Click here

  4. INSPECT FOR OIL LEAK

  5. INSTALL REAR ENGINE UNDER COVER RH

    Click here

  6. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }