AIR FUEL RATIO SENSOR(for Sensor 1) INSTALLATION

PROCEDURE


  1. INSTALL AIR FUEL RATIO SENSOR

    Tech Tips

    Perform "O2 Sensor Learning Value Reset" after replacing the air fuel ratio sensor.

    Click here


    1. A0030N9C01
      *a Torque Wrench Fulcrum Length

      Using SST, install the air fuel ratio sensor.

      SST
      09224-00011
      Torque:
      Specified tightening torque
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

      Note

      If the air fuel ratio sensor has been struck or dropped, replace it.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):

        45 N*m (459 kgf*cm, 33 ft.*lbf)

    2. A0030JRC01
      *a Air Fuel Ratio Sensor Connector
      *b Bracket
      *c 1.5 mm (0.0591 in.) or less

      Engage the air fuel ratio sensor connector to the bracket as shown in the illustration and connect the air fuel ratio sensor connector.

    3. Engage the 2 clamps.

  2. INSPECT FOR EXHAUST GAS LEAK

    Click here

  3. INSTALL NO. 1 ENGINE COVER

    Click here

  4. PERFORM INITIALIZATION


    1. Perform "O2 Sensor Learning Value Reset" after replacing the air fuel ratio sensor.

      Click here