ECD SYSTEM, Diagnostic DTC:P0651

DTC Code DTC Name
P0651 Sensor Reference Voltage "B" Circuit / Open

DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0651 Sensor Reference Voltage "B" Circuit / Open

Power voltage (5 V as standard) supplied from ECM to accelerator pedal sensor and fuel pressure sensor are lower or higher than threshold.

(1 trip detection logic)

  • Open or short in accelerator pedal sensor assembly circuit

  • Accelerator pedal sensor assembly

  • Open or short in fuel pressure sensor circuit

  • Fuel pressure sensor

  • ECM

 Comes on DTC stored

WIRING DIAGRAM

Refer to DTC P0192.

Click here

Refer to DTC P2122.

Click here

CAUTION / NOTICE / HINT

Note

When replacing the ECM, the ECM needs registration and initialization.

Click here

Tech Tips


  • When the ECM must be replaced, before replacing the ECM, perform the "Learning Values Save" function using the GTS. Then after installing the new ECM, perform all of the initialization/registrations for the "Learning Values Write" function by following the instructions shown on the GTS display.

  • Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

PROCEDURE


  1. CHECK DTC OUTPUT


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Enter the following menus: Engine and ECT / Trouble Codes.


      Powertrain > Engine and ECT > Trouble Codes

    4. Read the DTCs.

      OK
      DTCs related to open or short circuits in the accelerator pedal sensor and fuel pressure sensor circuit are not detected.
      Result
      Proceed to
      OK
      NG

    NG

    GO TO DTC CHART Click here

    OK

  2. REPLACE ECM


    1. Replace the ECM.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  3. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs.


      Powertrain > Engine and ECT > Clear DTCs

    4. Turn the ignition switch off and wait for 60 seconds or more [A].

    5. Perform road test [B].

    6. Repeat [A] and [B] for the number of trips detected.

    7. Enter the following menus: Engine and ECT / Trouble Codes.


      Powertrain > Engine and ECT > Trouble Codes

    8. Confirm that the DTC is not output again.

      Result
      Proceed to
      NEXT

    NEXT

    END