KNOCK SENSOR INSTALLATION

PROCEDURE

1. INSTALL KNOCK CONTROL SENSOR

   
   
   1. 

      *a

      Up

      Install the knock control sensor to the cylinder block sub-assembly with the bolt as shown in the illustration.

      Torque:

      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

      Note

      
      

      • If a component has been dropped or subjected to a strong impact, replace it.

      • Make sure that the knock control sensor is in the correct position.

      Tech Tips

      Perform "Inspection After Repair" after replacing the knock control sensor.

      Click here

   2. Connect the knock control sensor connector.

2. INSTALL INTAKE MANIFOLD

   Click here