CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. A012K4JC07
      *1 O-ring

      Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

      Note

      If reusing the crankshaft position sensor, be sure to inspect the O-ring.

    2. Install the crankshaft position sensor with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • If a component has been dropped or subjected to a strong impact, replace it.

      • Make sure that the O-ring is not damaged or does not jump out of position during installation.

    3. Connect the crankshaft position sensor connector.

  2. INSPECT FOR ENGINE OIL LEAK

  3. INSTALL REAR ENGINE UNDER COVER RH