CAMSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL CAMSHAFT POSITION SENSOR


    1. for Intake Side:


      1. A01T8SAC02
        *1 O-ring

        Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

        Note

        If reusing the camshaft position sensor, be sure to inspect the O-ring.

      2. Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

        Note


        • If a component has been dropped or subjected to a strong impact, replace it.

        • Make sure that the O-ring is not damaged or does not jump out of position during installation.

      3. Connect the camshaft position sensor connector.

    2. for Exhaust Side:


      1. A01T8SAC02
        *1 O-ring

        Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

        Note

        If reusing the camshaft position sensor, be sure to inspect the O-ring.

      2. Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

        Note


        • If a component has been dropped or subjected to a strong impact, replace it.

        • Make sure that the O-ring is not damaged or does not jump out of position during installation.

      3. Connect the camshaft position sensor connector.

  2. INSPECT FOR ENGINE OIL LEAK

  3. INSTALL NO. 2 CYLINDER HEAD COVER

    Click here