THROTTLE BODY REMOVAL

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01TAF3

      Disconnect the mass air flow meter sub-assembly connector and disengage the 2 wire harness clamps.

    2. Disengage the 2 clamps.

    3. Slide the clip and disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.

    4. Loosen the hose clamp and remove the air cleaner cap sub-assembly.

  4. REMOVE THROTTLE BODY ASSEMBLY


    1. A01TCD2

      Disconnect the throttle body assembly connector.

    2. Slide the 2 clips and disconnect the 2 water by-pass hoses.

    3. Type A:


      1. A01TDIR

        Remove the 2 bolts, 2 nuts and throttle body assembly from the intake manifold.

    4. Type B:


      1. A01TBGG

        Remove the 4 bolts and throttle body assembly from the intake manifold.

  5. REMOVE THROTTLE BODY GASKET


    1. A01T8TN

      Remove the throttle body gasket from the intake manifold.