HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL OXYGEN SENSOR


    1. B00426NC01
      *a Length of SST 30 mm (1.18 in.)
      *b Length of Torque Wrench 260 mm (10.2 in.)

      Using SST, install the oxygen sensor to the front exhaust pipe assembly.

      SST
      09224-00010
      Torque:
      without SST [Torque (N*m(kgf*cm, ft.*lbf))]
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST [Reading of Torque wrench (N*m(kgf*cm, ft.*lbf))]
      39 N*m  { 398 kgf*cm, 29 ft.*lbf }

      Note

      If a component has been dropped or subjected to a strong impact, replace it.

      Tech Tips


      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 260 mm (10.2 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

    2. Connect the oxygen sensor connector and wire harness clamp.

  2. INSPECT FOR EXHAUST GAS LEAK

  3. INSTALL FRONT NO. 3 ENGINE UNDER COVER (for Full Cover Type)

    Click here