AIR FUEL RATIO SENSOR INSTALLATION

PROCEDURE


  1. INSTALL AIR FUEL RATIO SENSOR


    1. B0043R6C02
      *a Length of SST 30 mm (1.18 in.)
      *b Length of Torque Wrench 260 mm (10.2 in.)

      Using SST, install the air fuel ratio sensor to the exhaust manifold.

      SST
      09224-00010
      Torque:
      without SST [Torque (N*m(kgf*cm, ft.*lbf))]
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST [Reading of Torque wrench (N*m(kgf*cm, ft.*lbf))]
      39 N*m  { 398 kgf*cm, 29 ft.*lbf }

      Note

      If a component has been dropped or subjected to a strong impact, replace it.

      Tech Tips


      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 260 mm (10.2 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click here

      • Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

        Click here

    2. Connect the air fuel ratio sensor wire from the wire harness clamp bracket.

    3. Connect the air fuel ratio sensor connector.

  2. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  4. INSPECT FOR EXHAUST GAS LEAK

  5. INSTALL NO. 2 CYLINDER HEAD COVER

    Click here

  6. INSTALL COWL TOP PANEL OUTER

    Tech Tips