RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT GLOW PLUG RELAY ASSEMBLY

    A01T9JEE02

    1. Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 - 4 Battery voltage not applied 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the glow plug relay assembly.

  2. INSPECT STARTER RELAY ASSEMBLY


    1. B0042UC

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the starter relay assembly.