STARTER(w/o Stop And Start System) INSTALLATION

PROCEDURE


  1. INSTALL STARTER ASSEMBLY


    1. Install the starter assembly with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    2. Connect terminal 30 with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    3. Connect the connector and engage the harness clamp.

    4. Close the terminal cap.

  2. INSTALL NO. 1 AIR TUBE

    Click here

  3. INSTALL NO. 2 AIR TUBE


  4. INSTALL NO. 3 AIR HOSE


  5. INSTALL AIR CLEANER CASE SUB-ASSEMBLY


  6. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


  7. INSTALL BATTERY


  8. INSTALL NO. 1 ENGINE UNDER COVER

  9. INSTALL NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)


  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here