STARTER(w/ Stop And Start System) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE NO. 1 ENGINE UNDER COVER

  5. REMOVE BATTERY

    Click here

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  8. REMOVE NO. 3 AIR HOSE

    Click here

  9. REMOVE NO. 2 AIR TUBE

    Click here

  10. REMOVE NO. 1 AIR TUBE

    Click here

  11. REMOVE STARTER ASSEMBLY


    1. A012IA4

      Open the terminal cap.

    2. Remove the nut and disconnect terminal 30.

    3. Disconnect the starter assembly connector.

    4. A012MJV

      Remove the 2 bolts and starter assembly.