STARTER(w/o Stop And Start System) INSTALLATION

PROCEDURE


  1. INSTALL STARTER ASSEMBLY


    1. Install the wire harness clamp bracket with the bolt.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }

    2. Install the starter assembly with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    3. Connect the connector.

    4. Connect terminal 30 with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    5. Close the terminal cap.

    6. Engage the 2 clamps.

  2. INSTALL FLYWHEEL HOUSING SIDE COVER


    1. A012F3J

      Insert the protruding portion of the flywheel housing side cover into the end of the cylinder block and while pushing it along the cylinder block, engage the claw with the cylinder block.

      Note


      • Make sure that the claw makes a click sound, indicating a tight fit.

      • Replace the flywheel housing side cover with a new one if it does not engage securely or is deformed.

  3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL