KNOCK SENSOR INSTALLATION

PROCEDURE


  1. INSTALL KNOCK SENSOR


    1. A012JW7C01
      *a Up

      Install the knock sensor to the cylinder block with the bolt as shown in the illustration.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Note


      • If a component has been dropped or subjected to a strong impact, replace it.

      • Make sure that the knock sensor is in the correct position.

      Tech Tips

      Perform "Inspection After Repairs" after replacing the knock sensor Click here.

    2. Connect the knock sensor connector.

  2. INSTALL INTAKE MANIFOLD

    Click here