CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL CRANK POSITION SENSOR


    1. A00Y59DC01
      *1 O-ring

      Apply a light coat of engine oil to the O-ring of the crank position sensor.

      Note

      If reusing the crank position sensor, be sure to inspect the O-ring.

    2. A00Y84H

      Install the crank position sensor with the bolt.

      Torque:
      8.8 N*m  { 90 kgf*cm, 78 in.*lbf }

      Note


      • If a component has been dropped or subjected to a strong impact, replace it.

      • Make sure that the O-ring is not damaged or does not jump out of position during installation.

    3. Connect the wire harness clamp.

    4. Connect the connector to the wire harness bracket.

    5. Connect the connector from the crank position sensor.

  2. INSTALL GENERATOR ASSEMBLY

    Click here