OIL PRESSURE SENSOR INSTALLATION

PROCEDURE

1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

   
   

   1. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note

      Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.

   2. Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

      Torque:

      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installation.

   3. Connect the oil pressure sender gauge assembly connector.

2. ADD ENGINE OIL

   Click here

3. INSPECT FOR OIL LEAK

   Click here

4. INSPECT ENGINE OIL LEVEL

   Click here

5. INSTALL OIL FILTER ELEMENT SERVICE HOLE COVER

   Click here