EXHAUST PIPE GAS CONTROL ACTUATOR REMOVAL

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER (for Half Cover Type)

    Click here

  2. REMOVE NO. 1 ENGINE UNDER COVER (for Metal Type)

    Click here

  3. DRAIN ENGINE COOLANT

    Click here

  4. REMOVE EXHAUST PIPE GAS CONTROL ACTUATOR


    1. A01T92Y

      Slide the 2 clips and disconnect the 2 water hoses.

    2. A01TDH1C01
      *1 Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, pry the portion shown in the illustration to disengage the spring.

    3. A01TAB5

      Remove the 3 bolts, 3 nuts, gasket and exhaust pipe gas control actuator case.

    4. A01TCRFC01
      *a Port A
      *b Port B

      While closing the port (A), apply compressed air to the port (B) to remove the exhaust pipe gas control actuator as shown in the illustration.

      Tech Tips

      Use a piece of cloth to catch the exhaust pipe gas control actuator.