EXHAUST MANIFOLD REMOVAL

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER (for Full Cover Type)

    Click here

  2. REMOVE FRONT NO. 3 ENGINE UNDER COVER (for Full Cover Type)

    Click here

  3. REMOVE AIR FUEL RATIO SENSOR

    Click here

  4. REMOVE WIRE HARNESS CLAMP BRACKET

    Click here

  5. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    1. B0044VD

      Remove the 4 bolts and No. 1 exhaust manifold heat insulator from the exhaust manifold.

  6. REMOVE FRONT CENTER FLOOR BRACE SUB-ASSEMBLY

    Click here

  7. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Front and Rear Catalyst)


    1. B0044G8

      Disconnect the heated oxygen sensor connector and wire harness clamp.

    2. B0044XS

      Remove the 4 bolts and 4 compression springs.

    3. Remove the front exhaust pipe assembly (TWC: Front and Rear Catalyst) from the 2 exhaust pipe supports.

    4. Remove the 2 gaskets from the front exhaust pipe assembly (TWC: Front and Rear Catalyst) and exhaust manifold.

  8. REMOVE MANIFOLD STAY


    1. B0043LJ

      w/ Drive shaft heat insulator sub-assembly:


      1. Remove the 2 nuts and drive shaft heat insulator sub-assembly.

    2. B0043ZD

      Remove the 3 bolts and manifold stay.

  9. REMOVE EXHAUST MANIFOLD


    1. B0044V2

      Remove the 5 nuts and exhaust manifold.

    2. Remove the exhaust manifold to head gasket.

  10. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    1. B0044F8

      Remove the 3 bolts and No. 2 exhaust manifold heat insulator from the exhaust manifold.