MONOLITHIC CONVERTER REMOVAL

PROCEDURE


  1. REMOVE AIR FUEL RATIO SENSOR


  2. REMOVE EXHAUST GAS TEMPERATURE SENSOR


  3. REMOVE DIFFERENTIAL PRESSURE SENSOR

    Click here

  4. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

    Click here

  5. REMOVE OUTER COWL TOP PANEL


  6. REMOVE FRONT CENTER FLOOR BRACE SUB-ASSEMBLY

    Click here

  7. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. B004377

      Remove the 4 bolts and 4 compression springs and disconnect the front exhaust pipe assembly from the exhaust manifold converter sub-assembly and tail exhaust pipe assembly.

    2. Remove the front exhaust pipe assembly from the 2 exhaust pipe supports.

    3. Remove the 2 gaskets from the exhaust manifold converter sub-assembly and front exhaust pipe assembly.

  8. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    1. B0042EE

      Detach the 2 clamps and disconnect the engine wire.

    2. Remove the 2 bolts and No. 1 exhaust manifold heat insulator.

  9. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY


    1. B00433A

      Remove the 2 bolts, 2 nuts and manifold stay.

    2. B0042DD

      Loosen the V-band clamp.

    3. Remove the 3 nuts, 3 bolts, V-band clamp, gasket, engine bracket and exhaust manifold converter sub-assembly.

      B0041Q1C01
      *1 Engine Bracket *2 Exhaust Manifold Converter Sub-assembly
      *3 No. 2 Manifold Stay - -