GLOW PLUG REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. REMOVE NO. 1 ENGINE COVER

    Click here

  3. WARM UP ENGINE

    Note

    The glow plug assembly may be damaged if it is removed before the engine is warmed up.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. REMOVE NO. 2 EGR PIPE SUB-ASSEMBLY

    Click here

  6. REMOVE ENGINE COVER BRACKET


    1. A012K1S

      Remove the bolt, nut and engine cover bracket.

  7. REMOVE NO. 1 GLOW PLUG CONNECTOR


    1. A012INF

      Disconnect the glow connector.

    2. Remove the bolt and disconnect the engine wire so that the glow plugs can be removed in a later step.

    3. A012GHN

      Remove the 4 grommets.

    4. A012N0U

      Disconnect the clamp from the bracket.

    5. A012J7Y

      Remove the 4 nuts and No. 1 glow plug connector.

  8. REMOVE GLOW PLUG ASSEMBLY


    1. A012JTU

      Using a 10 mm deep socket wrench, remove the 4 glow plug assemblies.

      Note

      Do not remove the glow plug assemblies before the engine is warmed up.