GLOW PLUG CONTROLLER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT WHEEL LH

  4. DISCONNECT FRONT FENDER LINER LH


    1. B0043WHC01
      *a 90°

      Using a screwdriver, turn the pin 90 degrees clockwise to remove the pin hold clip.

    2. B0044HT

      Remove the 2 screws.

    3. B00438J

      Remove the 2 clips and disconnect the front fender liner LH.

  5. REMOVE GLOW PLUG CONTROLLER


    1. B0042HY

      Disconnect the 4 glow plug controller connectors.

    2. B00440R

      Remove the 2 bolts and glow plug controller together with the No. 1 glow plug controller bracket from the vehicle body.

  6. REMOVE NO. 1 GLOW PLUG CONTROLLER BRACKET


    1. B0043R2

      Remove the 2 screws and No. 1 glow plug controller bracket from the glow plug controller.