GLOW PLUG(w/o Glow Plug Controller) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  3. WARM UP ENGINE

    Note

    The glow plug assembly may be damaged if it is removed before the engine is warmed up.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. REMOVE NO. 3 ENGINE COVER BRACKET


    1. A01TANS

      Disconnect the wire harness clamp.

    2. Remove the bolt and No. 3 engine cover bracket.

  6. REMOVE NO. 1 GLOW PLUG CONNECTOR


    1. A01T8NB

      Remove the 5 screw grommets.

    2. A01TB5MC01
      *1 Wire Harness

      Remove the nut and disconnect the wire harness.

    3. Remove the 4 nuts and No. 1 glow plug connector.

  7. REMOVE GLOW PLUG ASSEMBLY


    1. A01TDLQ

      Using a 10 mm deep socket wrench, remove the 4 glow plug assemblies.

      Note

      Do not remove the glow plug assemblies before the engine is warmed up.