FRONT DOOR BELT MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

    Click here

  4. REMOVE FRONT DOOR TRIM MOULDING LH

    Click here

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

    Click here

  6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  7. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH

    Click here

  8. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  9. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  10. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  11. REMOVE FRONT DOOR GLASS RUN LH

    Click here

  12. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH

    A002Q59E03

    1. Put protective tape around the front door belt moulding assembly.

    2. Remove the clip.

    3. Detach the 6 claws and remove the front bumper moulding assembly.

      Tech Tips

      If the claw labeled A is damaged, replace the front door belt moulding with a new front door belt moulding.

      Text in Illustration
      *1 Protective Tape
      *2 Claw A