HIGH INTENSITY DISCHARGE HEADLIGHT BULB REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT BUMPER COVER

    Click here

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH

    A002MG3

    1. Disconnect the connector.

    2. Turn the headlight light control ECU sub-assembly LH in the direction indicated by the arrow in the illustration to separate the headlight light control ECU sub-assembly LH from the headlight unit.

      Note


      • Do not apply excessive force using a tool.

      • Do not damage the headlight gasket or allow it to become contaminated with foreign matter. If the headlight gasket is damaged or contaminated, water may get into the headlight assembly, resulting in a malfunction of the headlight light control ECU sub-assembly LH.

    3. A002M41

      Turn the headlight light control ECU sub-assembly socket in the direction indicated by the arrow in the illustration to remove the headlight light control ECU sub-assembly LH.

      Note

      Do not pull the headlight light control ECU sub-assembly LH with the socket connected.

  5. REMOVE HEADLIGHT GASKET

    A002LHO

    1. Remove the headlight gasket from the headlight light control ECU sub-assembly LH.

  6. REMOVE DISCHARGE HEADLIGHT BULB

    A002O65E02

    1. Release the set spring lock in the order shown in the illustration and remove the discharge headlight bulb.

      Note

      Do not touch the discharge headlight bulb glass.