HEADLIGHT ASSEMBLY(for HID Headlight) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT BUMPER COVER

    Click here

  4. REMOVE FRONT FENDER REINFORCEMENT SUB-ASSEMBLY TOP LH

    A002LPA

    1. Remove the 2 clips.

    2. Detach the 2 claws to remove the front fender reinforcement sub-assembly top LH.

  5. REMOVE HEADLIGHT ASSEMBLY LH

    A002MVOE02
    Text in Illustration
    *1 Protective Tape
    *2 Bolt
    *3 Screw

    1. Put protective tape around the headlight assembly LH.

    2. Remove the bolt and 2 screws.

    3. Detach the claw.

    4. Disconnect each connector to remove the headlight assembly LH.