WIPER AND WASHER SYSTEM(w/ Rain Sensor) Washer Motor Circuit

DESCRIPTION

The windshield wiper relay receives washer switch information from the windshield wiper switch assembly and operates the windshield washer motor and pump assembly.

WIRING DIAGRAM

A002LY3E04

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (WINDSHIELD WASHER MOTOR - BATTERY)


    1. A002OQ2E02
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Windshield Washer Motor and Pump Assembly)

      Disconnect the A59 motor connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      A59-1 - Body ground Ignition switch ON 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


    1. A002MT9

      Remove the windshield washer motor Click here.

    2. Apply battery voltage to the windshield washer motor and check the operation of the windshield washer motor.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 1

      Battery negative (-) → Terminal 2

      		 Windshield washer motor operation is normal

    NG

    REPLACE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (WINDSHIELD WASHER MOTOR - WINDSHIELD WIPER RELAY AND BODY GROUND)

    A002O9ZE02
    Text in Illustration
    *1

    Front view of wire harness connector

    (to Windshield Washer Motor and Pump Assembly)
    *2

    Front view of wire harness connector

    (to Windshield Wiper Relay Assembly)

    1. Disconnect the A59 motor connector.

    2. Disconnect the H56 relay connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A59-2 - H56-25 (W) Always Below 1 Ω
      A59-2 - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. CHECK HARNESS AND CONNECTOR (WINDSHIELD WASHER MOTOR - WINDSHIELD WIPER SWITCH AND BODY GROUND)

    A002PXKE02
    Text in Illustration
    *1

    Front view of wire harness connector

    (to Windshield Washer Motor and Pump Assembly)
    *2

    Front view of wire harness connector

    (to Windshield Wiper Switch Assembly)

    1. Disconnect the A59 motor connector.

    2. Disconnect the H14 switch connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A59-2 - H14-3 (WF) Always Below 1 Ω
      H14-2 (EW) - Body ground Always Below 1 Ω
      H14-3 (WF) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR