REAR WIPER MOTOR INSTALLATION

PROCEDURE

INSTALL REAR WIPER MOTOR GROMMET
1. Text in Illustration
  
  *1 MP grease
  
  Apply MP grease to the entire inner surface of the wiper motor grommet.
  
  Tech Tips
  
  Make sure that the hole does not get clogged with grease and the grooves in the grommet are filled with grease.
2. Text in Illustration
  
  *1 Position Mark
  
  Install the rear wiper motor grommet with the position mark facing upward as shown in the illustration.
INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY
1. Temporarily install the rear wiper motor and bracket assembly with the 3 bolts.
2. Tighten the 3 bolts.
  
  Torque:
  
  5.5 N*m { 56 kgf*cm, 49 in.*lbf }
3. Connect the connector.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

Text in Illustration
*1	MP grease

Text in Illustration
*1	Position Mark

INSTALL REAR WIPER ARM

Operate the rear wiper, and stop the rear wiper motor at the automatic stop position.

Clean the serrations with a wire brush.

Text in Illustration

*1 Mark for Blade Position

Align the blade tip with the mark on the glass, as shown in the illustration.
Install the rear wiper arm with the nut.

Torque:

5.5 N*m { 56 kgf*cm, 49 in.*lbf }
Close the wiper arm head cap.