POWER WINDOW REGULATOR MOTOR(for Front Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY LH


    1. Apply MP grease to the sliding and rotating areas of the window regulator.

    2. A002LJ7E02
      Text in Illustration
      *1 Temporary Bolt

      Temporarily install the temporary bolt onto the window regulator.

    3. Insert the window regulator into the door panel. Use the temporary bolt to hang the window regulator on the door panel.

      Note

      Be careful not to drop the window regulator as it may become damaged.

    4. Temporarily install the window regulator with the 5 bolts.

    5. Tighten the 6 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    6. Connect the connector.

  2. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  3. INSTALL FRONT DOOR SERVICE HOLE COVER LH

    Click here

  4. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  5. INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH

    Click here

  6. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  7. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

    Click here

  8. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  9. INSTALL FRONT DOOR TRIM MOULDING LH

    Click here

  10. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH

    Click here

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.