FRONT PASSENGER SIDE POWER WINDOW SWITCH INSPECTION

PROCEDURE


  1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY


    1. A002NQWE01
      Text in Illustration
      *1

      Component without harness connected

      (Power Window Regulator Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      6 (UP) - 1 (GND) Manual up operation Below 1 Ω
      7 (DOWN) - 1 (GND) Manual down operation Below 1 Ω
      8 (AUTO) - 1 (GND) Auto up/down operation Below 1 Ω

      • If the result is not as specified, replace the power window regulator switch assembly.

    2. Check that the LED illuminates.


      1. Apply battery voltage to the power window regulator switch and check that the LED illuminates.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 4 (LED)

        Battery negative (-) → 1 (GND)

        		 LED illuminates

        • If the result is not as specified, replace the power window regulator switch assembly.