HOOD LOCK CONTROL CABLE ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)


    1. A002OCOE04
      Text in Illustration
      *1 String

      Tie the string that was passed through the engine compartment to the end of the hood lock control cable assembly as shown in the illustration.

    2. Pull the string until the hood lock control cable grommet contacts the dash panel, and then connect the clamps shown in the illustration to install the cable.

      A002N0YE02
      Text in Illustration
      *1 Hood Lock Control Cable Assembly *2 Clamp
      *3 Radiator Support Side *4 Headlight
      *5 Wire Harness *6 Wire Harness Clamp
      *7 Dash Panel *8 Grommet
      *9 Hood Lock Control Cable Clamp - -

  2. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)


    1. A002OCOE04
      Text in Illustration
      *1 String

      Tie the string that was passed through the engine compartment to the end of the hood lock control cable assembly as shown in the illustration.

    2. Pull the string until the hood lock control cable grommet contacts the dash panel, and then connect the clamps shown in the illustration to install the cable.

      A002NBHE02
      Text in Illustration
      *1 Hood Lock Control Cable Assembly *2 Clamp
      *3 Radiator Support Side *4 Headlight
      *5 Wire Harness *6 Wire Harness Clamp
      *7 Dash Panel *8 Grommet
      *9 Hood Lock Control Cable Clamp 10 Radiator Hose
      *11 Washer Hose *12 Washer Hose Clamp

  3. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. A002Q8S

      Connect the hood lock control cable assembly.

    2. Attach the 3 claws to install the hood lock control lever sub-assembly.

      Note

      Make sure the cable inside the cabin does not interfere with the clutch pedal, link or accelerator pedal.

  4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  5. INSTALL HOOD LOCK ASSEMBLY


    1. A002QOHE03
      Text in Illustration
      *1 MP grease

      Apply MP grease to the sliding areas of the lock.

    2. for LHD:


      1. A002MQX

        Connect the hood lock control cable.

      2. A002QC5

        Install the hood lock with the 3 bolts.

        Torque:
        7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

    3. for RHD:


      1. A002OZ1

        Connect the hood lock control cable.

      2. A002NJA

        Connect the connector.

      3. Install the hood lock with the 3 bolts.

        Torque:
        7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

  6. INSTALL NO. 1 WATER HOSE CLAMP BRACKET

    Click here

  7. INSTALL FRONT FENDER LINER LH


    1. Install the front fender liner Click here.

  8. INSTALL RADIATOR SUPPORT OPENING COVER

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.