ROOF HEADLINING DISASSEMBLY

PROCEDURE


  1. REMOVE NO. 1 ROOM LIGHT ASSEMBLY

    A002PZ7

    1. Disconnect the connector.

    2. Detach the 4 claws and remove the No. 1 room light.

  2. REMOVE VANITY LIGHT ASSEMBLY

    A002NLRC08
    *1 Claw (A)
    *2 Claw (B)
    *3 Bulb Holder

    Tech Tips

    Use the same procedure to remove the vanity light on the other side.


    1. Detach the 2 claws (A) and separate the bulb holder from the vanity light as shown in the illustration.

    2. Detach the claw (B) and remove the vanity light.

  3. REMOVE NO. 1 ROOF SILENCER PAD (w/o Roof Sunshade System)

    A002N0N

    1. Remove the 4 No. 1 roof silencer pads.

  4. REMOVE NO. 2 ROOF SILENCER PAD (w/o Roof Sunshade System)

    A002MD9

    1. Remove the No. 2 roof silencer pad.

  5. REMOVE NO. 2 ROOF HEADLINING PAD (w/ Roof Sunshade System)

    A002Q43

    1. Remove the 2 No. 2 roof headlining pads.

  6. REMOVE ROOF HEADLINING PAD

    A002Q74

    1. Remove the roof headlining pad.

  7. REMOVE ROOF HEADLINING PAD END

    A002P1O

    1. Remove the 2 roof headlining pad ends.

  8. REMOVE HEADLINING SUPPORT RETAINER

    A002NAA

    Tech Tips

    Use the same procedure to remove the headlining support retainer on the other side.


    1. Remove the headlining support retainer.

  9. REMOVE NO. 1 ROOF WIRE


    1. w/o Roof Sunshade System:


      1. Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining.

      2. Remove each piece of tape and the No. 1 roof wire.

      3. Remove the butyl tape remaining on the roof headlining.

        A002PNKC01
        *A w/o Pre-collision System *B w/ Pre-collision System
        *C w/ Rain Sensor, for LHD *D w/ Rain Sensor, for RHD
        *E w/ EC Mirror *F w/ Camera Heater
        *1 Visor Connector - -
        A002P7H Tape A002PY1 Butyl Tape

    2. w/ Roof Sunshade System:


      1. Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining.

      2. Remove each piece of tape and the No. 1 roof wire.

      3. Remove the butyl tape remaining on the roof headlining.

        A002MPBC01
        *A w/o Pre-collision System *B w/ Pre-collision System
        *C w/ Rain Sensor, for LHD *D w/ Rain Sensor, for RHD
        *E w/ EC Mirror *F w/ Camera Heater
        *1 Visor Connector - -
        A002P7H Tape A002PY1 Butyl Tape

  10. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

    Click here