REAR CENTER SEAT ASSEMBLY(for Rear No. 1 Seat) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

PROCEDURE


  1. INSTALL REAR CENTER SEAT ASSEMBLY


    1. A002M1P

      Place the rear center seat assembly in the cabin.

      Note

      Be careful not to damage the vehicle body or rear No. 1 seat assembly.

    2. Temporarily install the 2 bolts.

    3. Operate the rear center back lock control lever and raise the seatback.

    4. Lift up the seat track adjusting handle and move the seat to the foremost position.

    5. A002Q9M

      Temporarily install the 2 bolts.

    6. A002M1WE03

      Tighten the 4 bolts in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
    7. A002MGH

      Connect the connector.

    8. Attach the wire harness clamp by attaching the 2 claws.

    9. A002NPE

      Operate the rear back lock control lever RH and raise the rear No. 1 seatback LH.

  2. INSTALL REAR SEAT INNER TRACK BRACKET COVER LH


    1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    2. A002MLN

      Attach the guide and 3 claws to install the cover.

  3. INSTALL REAR SEAT INNER TRACK BRACKET COVER RH

    Tech Tips

    Use the same procedures described for the LH side.

  4. INSTALL INNER SEAT TRACK BRACKET COVER LH


    1. Lift up the seat track adjusting handle and move the seat to the foremost position.

    2. A002M6E

      Attach the 3 guides and 2 claws to install the cover.

  5. INSTALL INNER SEAT TRACK BRACKET COVER RH

    Tech Tips

    Use the same procedures described for the LH side.