CAMERA HEATER INSTALLATION

PROCEDURE


  1. INSTALL PRE-COLLISION SAFETY CITY HEATER

    Tech Tips


    • Perform this step only when necessary.

    • If a pre-collision safety city heater has been removed,replace it with a new one. Install a new pre-collision safety city heater with the pre-collision safety city heater wire as a set.

    • If the sticker is creased or folded it may result inan open circuit.

    • Water may enter and cause a short if the sticker adhesive layer and wiring layer are separated.


    1. Clean the windowshield glass surface.

    2. When work environment temperature is below 15°C:


      1. Using a heat light, heat the pre-collision safety city heater and windshield glass surface.

        Heating Temperature
        Item Temperature
        pre-collision safety city heater 15 to 80 °C (59 to 176 °F)
        Windshield glass 15 to 80 °C (59 to 176 °F)

        CAUTION:


        • Do not touch the heat light and heated parts, touching the heat light may result in burns.

        • Touching heated parts for a long time may result in burns.

        Note

        Do not heat the pre-collision safety city heater or windshield glass excessively.

    3. A002LK1C01
      *1 Tape
      *a Long connector
      *b Short connector

      Connect the 2 connectors to a new pre-collision safety city heater as shown in the illustration.

    4. Remove the release paper from the pre-collision safety city heater.

      Tech Tips

      After removing the release paper, keep the exposed adhesive free from foreign matter.

    5. Install the pre-collision safety city heater with pre-collision safety city heater wire by aligning it to the specified application position as shown in the illustration.

      A002MCWC01
      *a Specified Application Position - -
      A002P14 Black ceramic - -

      Note


      • Make sure that the sticker is within the black ceramic area.

      • The double-sided tape of a pre-collision safety city heater will deteriorate if it is detached. Make sure to replace the pre-collision safety city heater with a new one when reatt achment is necessary.

      Tech Tips

      Apply the pre-collision safety city heater along the bracket.

  2. INSTALL PRE-COLLISION SAFETY CITY HEATER WIRE


    1. A002NA9C01
      *a Clamp
      *b Guide

      Attach the clamp and 2 guides to install the pre-collision safety city heater wire.

  3. INSTALL PRE-COLLISION CITY SENSOR

    Click here